2023 John Deere 2 Series 2025R

MoreLess
Limited Time Offer!

Selling Price -

2023 John Deere 2 Series 2025R

  • Hydro transmission with TwinTouch™ pedals for ease of use
  • AutoConnect™ mid-mower deck can be installed or removed in less than 5 minutes

Features may include:

Durable, efficient, high-torque 3-cylinder diesel engine provides adequate power
  • Power is provided by a durable and efficient high-torque three-cylinder Yanmar® TNV Series diesel engine.
  • This series of engines was developed to meet Tier 4 Environmental Protection Agency (EPA) environmental requirements by featuring low levels of both exhaust and emissions.
  • YANMAR TNV SERIES ENGINE OFFERS THESE FEATURES:
  • Economical for good cooling and long life
  • Isolated engine provides reduced vibration and noise for the operator; indirect fuel injection uses a precombustion chamber to give the engine a smooth and quiet operation; aluminum-alloy piston with built-in steel struts are lightweight to reduce connection rod bearing loads and provide good heat transfer characteristics
  • Design permits tighter tolerances and neutralizes expansion of the piston, thereby reducing blow-by gas and less noise from the piston slap
  • Higher top rings on the piston and a thinner head gasket greatly reduces the volume of unburned waste gases and increases combustion efficiency
  • Timing-gear teeth have a designed roll-off profile giving almost no clash, no noise, and no backlash
  • High-torque reserve provides plenty of power under heavy load, yet retains excellent fuel economy
  • Easy access to engine check and fill points on the right-hand side of the tractor by removing the side panels
  • Fuel filter with replaceable element
  • Full-pressure lubrication system provides filtered oil under pressure to all vital engine parts
  • Glow plugs provide quick starts in temperatures down to -18°C (0°F)
  • Auto-bleed fuel system means there is no special bleeding required if the tractor runs out of fuel; this system will self-prime the injection pump, lines, and injectors, providing fast fuel recovery
  • Key start and shut off eliminates fuel shut-off knob
  • Electric solenoid shuts fuel supply off immediately when key is turned off
  • See-through coolant recovery tank permits operator to check coolant level without removing radiator cap
  • Dry-type air cleaner with safety element keeps dirt and other contaminants out of the engine
  • Safety element (second filter) will protect engine if primary filter would develop a leak
  • Protects engine when servicing primary filter
  • Air filter restriction indicator is standard equipment on the 2025R Tractor
  • Sealed-radiator compartment keeps trash and debris on outside of hood
  • Horizontal exhaust discharges fumes away from the operator station, reducing noise and improving operator visibility and comfort
The 2R Series are equipped with a two-range hydrostatic transmission (HST) incorporated in a die-cast aluminum transmission case. Fluid under pressure transmits engine power to the drive wheels via a closed-loop pump and motor arrangement. Infinite ground speeds allow the operator to match the speed of the tractor to the job.
  • No clutching for fast and easy direction changes
  • Twin Touch™ foot pedals for quick and easy forward/reverse operation
  • Transmission oil cooler cools transmission oil for longer transmission life
  • 2023
  • John Deere
  • 2 Series
  • 2025R
  • Compact
  • Model: 3TNV80F-NCJT
  • Yanmar®
  • SAE J1995 rated power: 23.9 hp (17.8 kW) / 24.2 PS at 3200 rpm
  • 3200 rpm
  • Natural
  • Final Tier 4
  • Three | Cast-in-block
  • 77 cu in. (1.267 L)
  • 3.2 in (80 mm)
  • 3.3 in. (84 mm)
  • Pressurized
  • Water pump
  • Dual element
  • At rated speed: 39.1 lb-ft (53.1 Nm)
  • Power take-off (PTO) power: 17.2 hp (12.8 kW) | Rear - 540 rpm / Mid - 2100 rpm
  • Indirect injection
  • Diesel
  • 23.1:01
  • Indirect injection
  • Hydrostatic - two range
  • Spur gear
  • Power steering
  • Wet disk
  • Wet disc
  • R3 Turf: 23x8.50-12 / R3 Radial: 220/55-R12 / R4 Industrial: 23x8.50-12
  • R3 Turf: 12-16.5 / R3 Radial: 280/70 R16 / R4 Industrial: 12-16.5
  • 500 CCA
  • 40 amp
  • Starter size: 1.6 hp (1.2 kW)
  • Remote control valves available: Two
  • Steering: 3.5 gpm (13.25 L/min) | Implement: 3.5 gpm (13.25 L/min) / 7.0 gpm (26.5 L/min)
  • 1987 psi (137 bar)
  • Gear
  • Limited Category 1
  • 63 in. (1600 mm)
  • Without brakes: 8.2 ft (2.51 m)
  • 5.39 gal. (20.4 L)
  • 1349 lb (612 kg)
  • 2425 lb (1100 kg)
  • 24-in. behind link arms: 915 lb (415 kg)
  • Platform - flat/straddle: Three-piece semi flat | Gear shift location - console/floor: Left-hand side
  • Open station: 1872 lb (849 kg) / Cab: 2392 lb (1085 kg)
  • 4WD
  •  Calculation is estimate only.
  •  
  •  
  •  
  •  
  •  
  •  
  •  Quotes are estimates only, actual rate may vary slightly.
  •  One-Way toll road charges will be the responsibility of the customer.
  •  Additional fees and/or duties may apply to International and non-continental US shipping requests.
  • Jeffersonville, New York
  • New
  • 2023
  • John Deere
  • 2 Series 2025R
  • Model: 3TNV80F-NCJT
  • 25
  • HYDROSTATIC
  • Diesel
  • Available
  • 4WD
Advertised pricing excludes applicable taxes title and licensing, dealer set up, destination, reconditioning and are subject to change without notice. Pricing may exclude any added parts, accessories or installation unless otherwise noted. Sale prices include all applicable offers. Not all options listed available on pre-owned models. Contact dealer for details.